For all your general datsun ramblings
kicker
Financial Member
Posts: 48 Joined: Sat Feb 04, 2012 10:45 pm
Location: 80085
Post
by kicker » Tue Sep 17, 2013 8:54 pm
Hi guys anyone know how to remove this piece of chrome moulding from a 330 260C?
I've got the rest of that section off and taken the single screw out holding it but it won't come off and I don't want to force it until I know how it comes off.
This bit here, it's the rear part of the trim that goes over the doors and is attached to the body.
Cheers
torqued
Datsun God
Posts: 2125 Joined: Sat Jul 19, 2008 11:49 am
aka: Adam
Location: Christchurch
Post
by torqued » Wed Sep 18, 2013 8:47 am
I use a wide bit of wood sit it in behind the chrome and soft hits of a hammer onto the wood
So damage yet
"It's ok, we know what to do...we talked about this a lot on the internet."
kicker
Financial Member
Posts: 48 Joined: Sat Feb 04, 2012 10:45 pm
Location: 80085
Post
by kicker » Wed Sep 18, 2013 9:02 pm
Turns out it has a couple bolts holding it on from the inside of the car.
Got it off now so all good
brocky41
Financial Member
Posts: 1764 Joined: Sat Jul 19, 2008 11:05 am
aka: Brocky
Location: Christchurch
Contact:
Post
by brocky41 » Wed Sep 18, 2013 9:19 pm
Yip was just about to say the two bolts from the inside - you have to remove the rear "c" piller cover to get to them.
If you snapped them off i do have spares
brocky41
Financial Member
Posts: 1764 Joined: Sat Jul 19, 2008 11:05 am
aka: Brocky
Location: Christchurch
Contact:
Post
by brocky41 » Wed Sep 18, 2013 9:21 pm
torqued wrote: I use a wide bit of wood sit it in behind the chrome and soft hits of a hammer onto the wood
So damage yet
260Cs have pretty much everything bolted or screwed down - even the sill trims have hidden bolts holding the end caps on lol
brocky41
Financial Member
Posts: 1764 Joined: Sat Jul 19, 2008 11:05 am
aka: Brocky
Location: Christchurch
Contact:
Post
by brocky41 » Wed Sep 18, 2013 9:22 pm
kicker wrote: Turns out it has a couple bolts holding it on from the inside of the car.
Got it off now so all good
Is this beast getting some paint??
kicker
Financial Member
Posts: 48 Joined: Sat Feb 04, 2012 10:45 pm
Location: 80085
Post
by kicker » Wed Sep 18, 2013 9:43 pm
Na no paint just yet, was investigating a little bit of rust.
I might grab a replacement off you though, I got it off safe then managed to break the plastic cap on the bottom edge haha
Actually there's a few things I'm looking for now, I'll send ya a PM