billet cnc RCA bump steer spacers for everything datsun

[volodkovich]

I'm keen for a set of 310 RCA's too.

[skdmrx]

28mm 510 310 910 etc etc RCA's are hot off the mill.I'm sure they'll fit heaps of other stuff too,80mm hole centres/40mm spigot.Fire me a PM if your keen $170 including Hi tensile metric fine bolts.
I've still got a couple of pairs of 1200/120y ones floating around too.

[Datto_610]

The spigot on my 180b steering arm is smaller than the spigot on my 910 strut haven't measured them properly but I'm sure a locator ring would work ok. So keen on a pair but so poor at the moment!

Sent from my GT-I9300 using Tapatalk 2

[skdmrx]

^^ PM sent

[woodies72coupe]

I could be keen on a pair too for my 310 struts.

Question is: How much do you need to lower a car before these become important?

[85_Z31]

Usually once your front suspension arms get close to parallel to the ground you can notice a bit of bump steer.

My own Z was that exact situation and RCA bump spacers made it drive sooooooooo much better, night and day diffierence stuff.

Johns doing a cracking good deal ( and excellent job ) on these, snap them up guys !

[torqued]

The spigot on my 180b steering arm is smaller than the spigot on my 910 strut haven't measured them properly but I'm sure a locator ring would work ok. So keen on a pair but so poor at the moment!

Sent from my GT-I9300 using Tapatalk 2

Work fine on my car,
910 Struts 510 lower arms.
That locator ring should have come with your struts

[joelbrown]

Usually once your front suspension arms get close to parallel to the ground you can notice a bit of bump steer.

My own Z was that exact situation and RCA bump spacers made it drive sooooooooo much better, night and day diffierence stuff.

Johns doing a cracking good deal ( and excellent job ) on these, snap them up guys !

The ute feels soo much better now

[skdmrx]

Glad they helped out Joel.You or Adam got any pics post install?

[torqued]

Not the best pic but I took this earlier