Craigs Sr20det 620 Ute

[Bartman]

I always wanted a 620. (now I own two..........lol)
These utes are teriffic! Parts are dirt cheap, and they are sooo easy to upgrade too!

[unlimitedpower]

Hey with the alternator thing thats actually really easy to do. What you need is the mount brackets etc from a FWD sr20 anything like primerea etc should be fine. Then look at bolting that up. They have alternator on the other side.
I have done this on a dummy block. Just not 100% on the pulley side of it but im pretty sure it all worked,

[Garth]

Awesome thanks for that! Collected one of those and it's looking like it could be a go. Cab is now off getting some attention so hopefully some nice pics to come soon. Just working on tidying up the chassis now

[Bartman]

I saw the cab today at Wal's.

[2 doors]

Hi all, this has had a little loving over the last couple of weeks and is now at the point where the engine bay is de-rusted and ready for sanding and priming, radiator has been mounted and the radiator support panel has been re-cessed to help with the fitment. There was a bit of damage to the drivers front corner which has been sorted and straightened, and under the dash the corrosion has been sorted.

[torqued]

Looks a little rough in photos, but it sure looks a lot tidier in person

[2 doors]

yeah true that, bare metal is a mare to photograph

[Garth]

Nice Wal looking good!

[2 doors]

after another week on this ,the cab is now in final undercoat, I can now start a career as a criminal as I have no fingerprints on either hand lol.

floor pan is sorted and chassis mounts are now as solid as the factory intended, the usual corrosion in the bottom of both A pillars and sills has been addressed .

all in all its looking very clean and tidy indeed.

[Garth]

Daaaaamn skippy looking really good!