Hi guys just thought I would share my project with you.
Its a 75 gn620 which I am in the middle of upgrading to an sr20, so far I have the engine mounted and have got it running . The next stage is to get a radiator, a short shifter and get a drive shaft made up which will be happening as soon as I have saved up some money saved up.
Sent from my GT-P5110 using Tapatalk
Jayden's 620
Jayden's 620
You do not have the required permissions to view the files attached to this post.
Jayden's 620
New mounting points and old engine
Sent from my GT-P5110 using Tapatalk
You do not have the required permissions to view the files attached to this post.
-
Bartman
- Committee Members
- Posts: 7303
- Joined: Sat Jul 19, 2008 9:04 am
- Location: Datsun City
- Location: Christchurch New Zealand!!!!
- Contact:
Re: Jayden's 620
nice one!
do you have a picture of the clearance of the drag link on the sump?
do you have a picture of the clearance of the drag link on the sump?
They don't call me the man with the rubber arm for nothing you know.............
Jayden's 620
Brought a radiator this morning. It's a 52mm thick half size Honda radiator
Sent from my Nexus 5 using Tapatalk
I think I might have some clearance issues
Has anyone used these products before?
http://www.trademe.co.nz/motors/car-par ... 963810.htm" onclick="window.open(this.href);return false;
http://www.trademe.co.nz/motors/car-par ... 029667.htm" onclick="window.open(this.href);return false;
They look pretty ugly but they will do the trick as the radiator outlets are a different size to the engine
I think I might have some clearance issues
Has anyone used these products before?
http://www.trademe.co.nz/motors/car-par ... 963810.htm" onclick="window.open(this.href);return false;
http://www.trademe.co.nz/motors/car-par ... 029667.htm" onclick="window.open(this.href);return false;
They look pretty ugly but they will do the trick as the radiator outlets are a different size to the engine
You do not have the required permissions to view the files attached to this post.
Jayden's 620
Tidied up the wiring in the engine bay a little bit and made a loom for the fuel pump and fuel sender unit. Also wired up the rev light's.
Sent from my Nexus 5 using Tapatalk
Sent from my Nexus 5 using Tapatalk
You do not have the required permissions to view the files attached to this post.
-
Bartman
- Committee Members
- Posts: 7303
- Joined: Sat Jul 19, 2008 9:04 am
- Location: Datsun City
- Location: Christchurch New Zealand!!!!
- Contact:
Re: Jayden's 620
I'm actually planning the exact same swap for my 620.
I have a motor from an s14.
Keep your updates coming.
I have a motor from an s14.
Keep your updates coming.
They don't call me the man with the rubber arm for nothing you know.............
-
Bartman
- Committee Members
- Posts: 7303
- Joined: Sat Jul 19, 2008 9:04 am
- Location: Datsun City
- Location: Christchurch New Zealand!!!!
- Contact:
Re: Jayden's 620
NA to begin with.
Then I'll likely fit an Eaton M62 supercharger. It looks like it should be pretty easy.
Then I'll likely fit an Eaton M62 supercharger. It looks like it should be pretty easy.
They don't call me the man with the rubber arm for nothing you know.............