WTB ca18de custom weber 4 port inlet manifold

[datso]

Anyone have this one for sale?

Lawrence I recall got it?

[nzdatman]

That is an eight port manifold.

[datso]

aha! thank you ! .....I was too

[Bartman]

Just get some flanges laser, or water jet cut from Aluminum, and get the TIG'd on to the CA18 sub manifold.

[nick_m]

^exactly. There isnt much too that manifold

[Bartman]

I'd probably get the flanges on both sides cut, then Aluminium tubes welded between them. You never know how nicely the factory flange would weld. (I had a terrible time with an SC14 discharge manifold)

[datso]

Just to let peeps know if you are making such a manifold its only possible on the 8 port head
The 4 port head has totally and incorrect location of ports in this area and I only found out
too late when I tried to place the weber flanges on.
There is a big bias on the 4 port head and makes it impossible to use the primary manifold.
regards, d

[2 doors]

Just to let peeps know if you are making such a manifold its only possible on the 8 port head
The 4 port head has totally and incorrect location of ports in this area and I only found out
too late when I tried to place the weber flanges on.
There is a big bias on the 4 port head and makes it impossible to use the primary manifold.
regards, d

were you trying to mate the factory inlet flange to a weber flange?
if so could you get a new head flange cut and weld tubes between the flanges as bart describes

[datso]

yep will have to be all custom pretty much

will use factory flange to make a new one but ports are 62mm x 44mm which are massive ports
and the oval shape will be hard to taper into custom tubing but have no other choice as 4 port
heads dont come around often and worthwhile to hold onto.